Advanced Settings

With the unit powered ON, press and hold the MODE button for 6 seconds to enter the advanced settings menu.

The following parameters are available:

P1 – Automatic Defrost Interval
Sets the compressor operating time before the unit starts a self-defrost cycle.

• Setting range: 00–60 minutes
• Default: 00
• Note: A setting of 00 enables automatic self-defrosting.

P2 – Defrost Duration
Sets the length of the defrost cycle.

• Setting range: 08–15 minutes
• Default: 08 minutes

P3 – Ambient Temperature
Displays the current ambient temperature.

P4 – Coil Temperature
Displays the current coil temperature.

P5 – Built-in Water Pump
Enables or disables the built-in water pump.

• O = Water pump enabled (default)
• C = Water pump disabled

Navigating the Advanced Settings

• Press the MODE button briefly to cycle through P1–P5.
• Use the ▲ (Increase) and ▼ (Decrease) buttons to adjust the selected setting.

Humidity Calibration

The humidity sensor can be calibrated within a range of 0–9% RH.

• Calibration range: 0–9% RH
• If the humidity reading differs by more than 9% RH, calibration is not possible.
• Under normal operating conditions, the sensor deviation should remain within the adjustable range.